Pyro Industries Quest Plus Instruções de Operação descarregar pdf (Página 12)

Thermos tat Installation

NOTE: ALWAYS DISCONNECT POWER BEFORE PERFORMING THE

THERMOSTAT INSTALLATION.

To Install A Wall

Check the type of thermostat you are about to install, Solid State Electrical thermostats are

NOT

approved for use with the Quest Series pellet stoves. Consult your authorized Whitfield Dealer for more

details.

Unplug your stove from the wall outlet

Locate the thermostat connection block on the back of the freestand stove, and on the left side of an

insert stove.

Remove the jumper wire from the "jacks" on the connection block.

Insert the two wires from your thermostat into the jacks (one per jack).

Plug in the stove and you are ready to operate with your thermostat!

NOTE:

If the jumper wire

missing, and you do not have a thermostat installed, your stove will operate

on Heat Output position

all the time and at all settings.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Sem comentários

Pyro Industries Quest Plus Instruções de Operação Página 12