Pyro Industries Advantage Plus Instruções de Operação descarregar pdf (Página 25)

Built In Heater Installation

DO NOT BLOCK

VENT OPENING

The Advantage Insert may be framed

directly into a wall. Below are two (2)

examples of this. The exhaust installation

requirements are the same as for a

Freestanding stove. Refer to “Installing

your Freestanding Stove” for information

about installing and proper hook-up of

the exhaust.

Stove Dimensions for the Advantage Plus Insert that will be Enclosed within the frame work

are HEIGHT (20 1/4”) WIDTH (24”) DEPTH (13 1/2” + OR – 1/4”).

#2) This example shows the

exhaust vented vertical off a

cleanout Tee. This shows a

Chase to enclose the pipe.

** The Framing opening for

this installation needs to be:

HEIGHT= 22 1/2”

WIDTH = 39 3/4”

DEPTH = 24”

#1) This example

shows the exhaust

directly venting to the

outside horizontally to

the rear of the stove.

** The Framing open-

ing for this installation

needs to be:

HEIGHT= 24”

WIDTH = 34”

DEPTH = 14”

Wood Frame

6”

Min.

12”Min.

Shroud

1”

Minimum

Air Gap

Wall

Thimble

Type “L”

Vent Pipe

45 Degree

Elbow OR

End Cap

Wood Frame

3”

Minimum

Air Gap

Pipe

Stand-off

Bracket

Fire

Stop

Clean

Out

Tee

Type “L”

Vent Pipe

Shroud

6”

Min.

DO NOT BLOCK

VENT OPENING

NOTE: For Built-In Installations You Must

Order Enclosure Kit #11950055.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 36 37

Comentários a estes Manuais

Sem comentários

Pyro Industries Advantage Plus Instruções de Operação Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Pyro Industries Advantage Plus